Product Description:

The MHP112A-024-HP0-ANNNNN is a synchronous servo motor produced by Bosch Rexroth Indramat within the MHP Synchronous Motors series. As part of a closed-loop drive system, the motor converts commanded current into mechanical rotation for positioning or speed-controlled industrial axes such as gantry slides, packaging stations, and material-handling actuators. When paired with a compatible drive, it supports accurate motion control in equipment that must respond consistently to changing load conditions.

This model delivers a continuous standstill torque of 15.0 Nm when cooled only by natural convection, allowing constant load support without forced airflow. Rotor position is reported through an incremental encoder that outputs 2048 increments per revolution, providing fine resolution for the drive controller. Mechanical power leaves the unit through a keyed shaft with a sealing ring; the key helps prevent slip under cyclic torque, while the seal limits lubricant loss and dust entry. The housing is sealed to IP65, so internal components remain protected from process dust and water jets. Power enters on side A through a right-angle connector, which keeps cable runs aligned with adjacent machine wiring and helps reduce bend stress.

The motor operates in ambient temperatures from 0 to +40 °C; staying within this range helps avoid thermal derating and preserves bearing grease life. The windings use insulation class F, allowing maximum winding temperatures up to 155 °C during temporary load peaks. The unit is supplied without a holding brake, so any static load must be restrained by external mechanics or drive torque when power is off. Electromagnetic behavior matches winding code 024, which corresponds to the resistance and inductance values expected by compatible drives, while the 112 frame size provides a balance between torque density and inertia for medium-capacity axes.