Product Description:

Bosch Rexroth Indramat produces the MHP095C-035-HP1-ANNNNN as part of the MHP Synchronous Motors series. The unit is intended for closed-loop drive systems that require accurate torque and speed control in packaging, material-handling, and machining axes. By converting electrical energy into precise rotary motion, it supports coordinated multi-axis automation. It is well suited to applications that must accelerate, hold position, and follow commanded speed changes with repeatable response.

At standstill, the motor delivers a continuous torque between 23.0 to 28.0 Nm under its standard cooling arrangement. Operation is supported in ambient conditions from 0 to +40 °C, so the drive can be installed in standard factory environments without additional climate control. The housing carries a protection rating of IP65, which seals internal components against dust ingress and low-pressure water jets. Windings are built to insulation class F, allowing winding temperatures up to 155 °C before degradation and providing thermal headroom during cyclic duty. Rotor position is reported through an incremental encoder with 2048 increments, providing high-resolution feedback for fine velocity and positioning loops. The size code 095 and C length give the motor a medium frame, while winding code 035 matches it to compatible drive current and voltage requirements.

The mechanical interface uses a keyed shaft with a sealing ring, which simplifies coupling while helping block lubricant migration along the journal. For power-off holding demands, the integrated brake applies 22.0 Nm of static torque to help prevent vertical loads from drifting. Mains conductors reach the stator through a connector on side A, easing cable routing inside compact enclosures. Heat is removed solely by natural convection, so the motor operates without an external fan. This arrangement keeps the housing free of auxiliary cooling hardware and supports installation where simple airflow management is preferred.