Product Description:

The MHP093C-058-HG0-AFNNNN is a synchronous motor produced by Bosch Rexroth Indramat within the MHP Synchronous Motors series. It is designed to supply controlled rotary torque for positioning tables, packaging axes, and material-handling stations where repeatable speed and angle control are critical. By combining permanent-magnet excitation with digital drive technology, the unit converts regulated drive current into mechanical power for industrial automation tasks that demand high accuracy and continuous duty.

At the mechanical level, the motor can deliver a continuous standstill torque of 23.0–28.0 Nm. Thermal management is provided by a liquid cooling housing that removes heat directly from the stator, allowing higher overload margins without exceeding winding limits. The housing is sealed to IP65, so dust and water jets do not compromise operation on exposed machine frames. Position feedback is supplied by an incremental encoder (2048 increments), giving the controller fine resolution for velocity loops and homing cycles. Electrically, winding code 058 identifies the coil resistance and inductance values used by matched Indramat drive amplifiers. Motor size 093 and length C indicate the frame envelope used for standardized mounting interfaces, and the model is supplied without a holding brake to reduce mass where passive shaft locking is unnecessary.

The permitted ambient range is 0 to +40 °C, which supports operation in typical industrial indoor conditions. Output torque is transmitted through a plain shaft with a sealing ring, which helps block lubricant escape and contaminants at the coupling face. Electrical power reaches the stator through a connector on side A, simplifying cable routing along gantry beams. Internal insulation is classified as class F, supporting winding temperatures up to 155 °C during intermittent peaks. The motor can be integrated with motion systems that match its encoder format, cooling circuit, and enclosure protection.