Product Description:

The MHP093C-035-HP1-BNNNNN synchronous servo motor is manufactured by Bosch Rexroth Indramat and belongs to the MHP Synchronous Motors series. It is intended for closed-loop axes in packaging, printing, and general automation, where it converts electrical energy into rotary motion while supplying consistent torque and precise velocity control. By integrating permanent-magnet technology, encoder feedback, and a sealed construction, the unit serves as a compact drive solution for equipment that requires dependable positioning under continuous duty.

Under natural convection cooling, the motor delivers a continuous standstill torque of 23.0 to 28.0 Nm, enabling it to hold or index loads without forced-air assistance. The stator is wound to code 035, a designation that matches drive modules of the corresponding current and voltage class. Environmental suitability comes from an IP65 enclosure, so dust ingress and water jets do not interrupt operation. Position and speed data are generated by an incremental encoder with 2048 increments, giving the controller fine resolution for tight servo loops. Thermal integrity is maintained within an ambient range of 0 to +40 °C, matching typical cabinet climates in standard factory halls. Additional mechanical parameters are set by the C length variant, which balances rotor inertia against stall torque.

Application integration is simplified by the keyed shaft with sealing ring, which provides positive mechanical coupling while also blocking lubricant migration into the bearing cavity. A permanent-magnet holding brake rated at 20.0 Nm secures vertical or suspended loads during power-off conditions. The windings use F-class insulation, permitting temperatures up to 155 °C without degradation. Finally, power leads exit through a connector on side B, aligning with cabinet layouts where the 093-frame motor must be cabled from the rear.