Product Description:

The MHP093B-035-HG1-ANNNNN is a synchronous servo motor produced by Bosch Rexroth Indramat as part of the MHP Synchronous Motors series. The unit converts drive current into controlled mechanical rotation, allowing tight velocity and positioning loops in automated assembly cells, pick-and-place modules, and general machine tooling equipment. Its design couples directly to Rexroth digital drive controllers and provides the mechanical, electrical, and feedback interfaces needed for coordinated multi-axis motion in industrial automation. This arrangement supports synchronized axis control where stable torque response and repeatable stopping accuracy are required throughout the motion cycle.

Rated for environments from 0 to +40 °C, the motor operates without derating inside sealed cabinets or on open frames. With natural convection cooling, it can deliver a continuous standstill torque of 17.5 to 20.0 Nm. A plain shaft with a sealing ring transmits torque while helping prevent lubricant escape, and the enclosure carries an IP65 rating against dust and water jets. Power enters through a connector on side A, matching standard MHP cabling. The size code 093 and length code B establish the motor's mechanical envelope for compact servo installations.

A factory-installed holding brake secures the rotor when power is removed and provides 20.0 Nm of static torque for vertical or load-holding axes. This brake helps keep the shaft stationary after shutdown when the driven load could otherwise drift. Insulation class F supports winding temperatures up to 155 °C during intermittent duty. Position and speed data are sourced from an incremental encoder with 2048 increments, giving the drive fine-resolution feedback during acceleration and settling. Electromagnetic behavior is set by winding code 035, which corresponds to the coil resistance and inductance values used with a compatible converter.