Product Description:

The MHP093B-035-HG0-BNNNNN is a synchronous servo motor produced by Bosch Rexroth Indramat within the MHP Synchronous Motors series. Used in industrial automation, the unit converts controlled three-phase electrical energy into rotational motion for positioning or cyclic drives where precise speed and torque control are required. This type of motor is suited to coordinated axes that must respond predictably during repeated starts, stops, and speed changes. The motor is delivered without a holding brake, so any static load must be secured by the external drive or by mechanical locking hardware.

The rotor can deliver a continuous standstill torque of 17.5 to 20.0 Nm, giving the axis a stable source of static torque while the shaft remains motionless. Winding code 035 identifies the electrical characteristics, including resistance and inductance, that the matching drive controller must accommodate. Position feedback is provided by an incremental encoder with 2048 increments, and this resolution supports fine velocity control together with repeatable homing behavior. The housing carries an IP65 rating, which protects internal components against dust and low-pressure water jets. A plain shaft with a sealing ring helps protect the bearing area from contaminant ingress and lubricant loss during service.

Thermal operation is permitted in ambient air from 0 to +40 °C, so the surrounding machine space must stay within that range to maintain nominal output. The windings use class F insulation, allowing conductor temperatures up to 155 °C before insulation breakdown becomes a concern during demanding cycles. Power is routed through a connector on side B, which supports orderly cable routing when several motors are installed along the same machine section. Heat is removed by natural convection, so the installation must provide enough free air around the housing when the application runs near the upper end of its continuous torque capability.