Product Description:

The MHP071B-035-HP0-UNNNNN is a synchronous servo motor produced by Bosch Rexroth Indramat and assigned to the MHP Synchronous Motors series. It converts electrical power from a compatible drive into controlled torque and speed for indexing tables, pick-and-place arms, and other precision axes used in industrial automation. The motor supports incremental feedback for closed-loop control and uses a sealed construction that allows installation in environments exposed to dust or splashing fluids. This combination supports accurate motion during repeated start, stop, and positioning cycles.

With natural cooling at standstill, the rotor can develop 8.0 Nm of continuous torque, giving the drive margin for constant loads during positioning. Mechanical coupling is handled by a keyed shaft with a sealing ring, providing positive torque transmission while helping prevent lubricant from escaping along the shaft bore. Position data is returned through an incremental encoder with 2048 increments, letting the controller resolve sub-millimeter moves. Power enters through a connector that can be turned 270°, so the cable exit can be oriented toward the cabinet regardless of mounting angle. The motor uses winding code 035, which sets the rated voltage, current, and back EMF expected by the drive.

Thermal management relies on natural convection, so airflow around the frame is sufficient within the allowed 0 to +40 °C ambient range when the windings operate under insulation class F limits. Because the unit is supplied without a holding brake, any static load must be secured by drive torque or an external lock during power off. It belongs to frame size 71, which suits compact machinery that still demands high dynamic response, and its sealing system carries an IP65 rating that blocks dust and water jets. That housing protection helps the motor remain suitable for equipment installed near washdown areas, transfer stations, and other work zones where light fluid exposure can occur.