MHD112C-024-PG3-AN Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911279598
The Bosch Rexroth Indramat MHD112C-024-PG3-AN is a servo motor from the MHD Synchronous Motors series. It features a continuous torque at standstill of 38 Nm, liquid cooling, and an IP65 degree of protection. The motor is equipped with a holding brake, a digital servo feedback encoder, and an insulation class F.
Internal Product Review
The MHD112C-024-PG3-AN is a Bosch Rexroth Indramat servo motor with liquid cooling and IP65 protection. Digital servo feedback with integrated encoder and absolute position detection beyond 4096 revolutions support accurate closed-loop motion control. A 70.0 Nm holding brake complements 38.0 Nm continuous standstill torque, making this unit a strong choice for demanding servo axes.
Have a part to sell?
Wake Industrial Warranty
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MHD112C-024-PG3-AN belongs to the MHD Synchronous Motors series produced by Bosch Rexroth Indramat. It is a permanent-magnet AC servo motor. Its design supports precise torque response during acceleration, steady-speed operation, and repeated positioning cycles. It is intended for closed-loop motion axes in industrial automation, where precise velocity and position control are required for machining centers, handling modules, and packaging equipment.
At standstill the motor can deliver 38.0 Nm of continuous torque, which is the maximum continuous load it can hold during static positioning without overheating. The housing is sealed to IP65, keeping dust and low-pressure water jets away from the windings and the digital feedback device. Heat is removed by liquid cooling, allowing the thermally dense stator to sustain its rated output even when mounted in confined cabinets. A square 192 mm flange provides the mechanical interface for rigid coupling to machine frames, and the optical encoder achieves a system accuracy of ±0.5 angular minutes, supporting tight contouring tolerances. Position data are transmitted as an absolute value over more than 4096 revolutions, and the integrated digital servo feedback eliminates the need for external measuring transducers. Insulation class F materials permit a 155 °C winding temperature, and winding code 024 indicates the electrical resistance and inductance expected by the drive.
The motor includes a holding brake rated at 70.0 Nm, so vertical axes can remain locked during power loss without relying on external clamps. The motor can be stored between -20 to +80 °C and operated in ambient air from 0 to 40 °C, provided installation stays below the 1000 m maximum setup height. A centering pilot of 130 mm aligns the plain shaft with high concentricity, and a shaft seal blocks coolant or oil from migrating along the journal. Power is routed through a connector on side A, and the output shaft is suited to direct couplings where keyed torque transmission is not required.
