Product Description:

The MHD112C-024-PG2-AN is a servo motor produced by Bosch Rexroth Indramat for the MHD Synchronous Motors series. It interfaces with a regulated drive to deliver commanded torque and speed in automated production equipment where accurate response and high duty cycles are required. By integrating a digital servo feedback encoder into the housing, the unit supplies precise rotor position data for closed-loop control without external transducers. This arrangement lets the drive monitor motion continuously during acceleration, deceleration, and holding phases.

Mechanical and thermal limits set the continuous performance range. At standstill, the rotor can provide 38.0 Nm of torque without exceeding thermal rise, a figure influenced by the winding code 024 and the C-length stator stack. Precise centering on mounting surfaces is aided by a 130 mm pilot, while the square flange spans 192 mm, matching standard IEC interfaces for gearboxes or direct-drive couplings. The stator jacket uses liquid cooling to transfer heat to an external circuit, allowing full-load operation in cabinets that lack strong airflow. This cooling method moves thermal energy away from the housing and supports dense machine layouts. Size code 112 provides internal space for conductors that carry the required current density.

The integrated brake clamps the shaft with 32.0 Nm of holding torque when the drive is disabled, preventing back-driving on vertical axes. Power conductors reach the stator through an output connector oriented toward side A, simplifying cable routing in tight machine frames. A plain shaft with a shaft seal keeps lubricant inside the mechanics and blocks contaminants. Position feedback remains absolute across more than 4096 revolutions, so the axis maintains its coordinate after power removal. These characteristics suit gantry axes and press feeds that demand short indexing times and secure static holding.