Product Description:

Bosch Rexroth Indramat manufactures the MHD112C-024-NP2-AN as part of the MHD Synchronous Motors series. This servo motor is intended to deliver closed-loop rotary motion for automated packaging, material handling, and forming equipment where precise speed and torque regulation are required. Its electronically commutated windings accept three-phase power from an inverter and convert it into smooth torque without maintenance-heavy brushes, allowing synchronized multi-axis coordination across conveyor gantries, pick-and-place heads, and forming presses.

In continuous operation, the motor delivers 38.0 Nm of torque at standstill, and heat is removed by liquid cooling routed through the stator jacket. A 192 mm square flange sets the mounting footprint, while the sealed construction maintains IP65 protection against dust and low-pressure water. Rated ambient service is 0 to 40 °C, so the motor can operate in typical indoor conditions without derating. Additional design points include a keyed shaft, F-class winding insulation, and an output connector oriented toward side A for simple cable routing. Coolant passages in the stator jacket keep winding temperature within acceptable limits, so the motor can sustain high RMS currents during cyclic duty typical of servo presses or indexing tables without overheating.

The unit can be stored at temperatures from -20 to +80 °C and installed at elevations up to 1000 m above sea level without adjustment. A built-in holding brake provides 32.0 Nm of static torque to secure vertical loads when power is removed, and a shaft seal helps limit contamination at the output end. Position feedback is managed by a digital servo encoder that works on an optical principle and delivers a system accuracy of ± 0.5 angular minutes through relative detection. Mechanical alignment during installation is simplified by a 130 mm centering diameter, and the motor is identified by size 112, length C, and winding code 024.