Product Description:

The MHD112C-024-NP0-BP is a servo motor manufactured by Bosch Rexroth Indramat as part of the MHD Synchronous Motors series. It is intended for closed-loop positioning and speed control in automated machinery where precise dynamics and feedback are required. The unit integrates an optical digital servo feedback encoder that delivers relative position data to the drive controller and supports accurate monitoring of rotor movement during operation. A keyed shaft transmits torque to the load, while an output connector on side B supplies stator power and helps keep cable routing compact inside machine enclosures.

A centering collar of 130 mm aligns the 192 mm square flange, and four through-holes on that flange provide rigid seating on the machine face. Overall stator length follows code C, which provides a practical balance of inertia and torque density for this frame size. At standstill, the motor can deliver 38.0 Nm of continuous torque with winding code 024 in size 112 laminations. Protection level IP65 seals the housing against dust and water jets. The windings are enclosed in an IP68 section, and the high-speed digital feedback format supplies high-resolution signals while the optical measuring method helps reduce electrical interference.

The motor may be stored between -20 to +80 °C and operated continuously from 0 to 40 °C when installed no higher than 1000 m above mean sea level. The windings use Class F insulation to tolerate internal temperatures up to 155 °C, and a shaft seal helps block coolant or oil ingress at the output end. System precision is rated at ± 0.5 angular minutes, which supports tight registration moves in packaging or material-handling axes. Because the motor is supplied without a holding brake, any static load must be supported by the drive's torque or by an external clamp.