MHD112C-024-NG2-AN Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911278181
The Bosch Rexroth Indramat MHD112C-024-NG2-AN is a servo motor from the MHD Synchronous Motors series, featuring a continuous torque at standstill of 38.0 Nm and liquid cooling. It comes with digital servo feedback for position detection, an IP65 protection rating, and a holding brake with 32.0 Nm brake torque. The motor includes a plain shaft design, a 192 mm flange size, and supports an operating temperature range from 0 to 40 °C.
Internal Product Review
The MHD112C-024-NG2-AN is a Bosch Rexroth Indramat servo motor from the MHD Synchronous Motors series with liquid cooling and IP65 protection. Digital servo feedback (HSF) and ±0.5 angular-minute system accuracy support precise motion control in demanding axis applications. A 38.0 Nm continuous standstill torque paired with a 32.0 Nm holding brake makes the unit a strong choice for controlled positioning.
Have a part to sell?
Wake Industrial Warranty
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
Bosch Rexroth Indramat manufactures the MHD112C-024-NG2-AN within the MHD Synchronous Motors series. The unit functions as a rotary servo axis for industrial automation, converting drive commands into precise motion for packaging lines, gantry stages, and forming presses. Permanent-magnet excitation, closed-loop electronics, and a coolant jacket allow consistent torque production in confined control cabinets where heat buildup and response time are tightly controlled. Its design supports high duty cycles while preserving positional fidelity during repeated starts and stops.
The motor delivers 38.0 Nm of continuous standstill torque, and this output is supported by the liquid cooling housing that passes coolant through the stator jacket. The enclosure meets IP65, which helps keep process dust and washdown spray away from internal parts, and alignment to the machine face is set by a 130 mm centering diameter behind the 192 mm flange. Rotor position is monitored with digital servo feedback (HSF), which is read optically and works with the drive's relative evaluation scheme. Combined with system precision of ±0.5 angular minutes, this feedback supports small incremental moves without cumulative error. The active core uses motor size 112 and length code C, while winding code 024 indicates the electrical characteristics used with 400 V class inverters.
The integrated holding brake clamps the shaft with 32.0 Nm when power is removed, supporting vertical or suspended loads during an emergency stop. Safe operation is permitted from 0 to 40 °C, and the windings use Class F insulation to withstand higher internal temperatures during overload peaks. A shaft seal helps block coolant or oil migration, the plain shaft mates to compliant couplings, and the output connector on side A simplifies cable routing. Installation is permitted up to 1000 m above mean sea level, and storage from -20 to +80 °C helps preserve the magnets and insulation while the motor is not in use. Because position detection is relative, the axis must be homed after each startup.
