Product Description:

The MHD095C-058-NG1-RN is a servo motor built by Bosch Rexroth Indramat for the MHD Synchronous Motors series. It converts electrical energy into controllable rotary motion so that automated transfer stations, gantry axes, and other industrial processes can position loads quickly and accurately. Within a drive system, it pairs with a compatible digital controller and uses its internal feedback to keep speed and angle synchronized with the command profile. This supports repeatable motion on axes that must handle frequent starts, stops, and speed changes during normal operation.

Under continuous stall conditions, the rotor can hold 23.0 Nm of torque, providing steady force for vertical or high-inertia loads. A built-in brake rated at 22.0 Nm supplements that holding capability during power-off states. Heat generated by the windings is removed through liquid cooling, which allows the motor to maintain rated output without additional external airflow. The mounting interface uses a 140/150 mm square flange, and alignment during installation is centered by a 130 mm pilot. Motion feedback is supplied through digital servo feedback (HSF), giving high-resolution position data to the drive for accurate closed-loop control, while electrical constants correspond to winding code 058 for use with compatible medium-voltage inverters.

The shaft is finished as a plain shaft, permitting direct coupling through clamping hubs or keyed bushings selected for the application. Power is introduced through a power connector, and the cable outlet is oriented to the right side of the housing to simplify routing where space is limited. A shaft seal helps limit lubricant escape and particle ingress, while relative position detection supports homing sequences without requiring an absolute encoder. The size 095 housing with length code C gives the motor a moderate installation envelope for applications that need higher torque density without moving to a larger frame.