Product Description:

The MHD095C-058-NG0-AN is a servo motor produced by Bosch Rexroth Indramat within the MHD Synchronous Motors series. It converts drive controller commands into rotary motion for positioning, speed control, and cyclic duties in automated packaging lines, machine tools, and material-handling stations where repeatable motion is required. Electrical power reaches the stator through an output connector on side A, which helps keep cable routing clear near the mounting face.

For continuous operation, the motor develops 23.0 Nm of torque at standstill, which is the load it can hold without movement while energized. Thermal energy is removed through liquid cooling, so the stator windings remain within Insulation Class F temperature limits even at maximum current. A sealing system rated IP65 blocks dust and water jets, allowing installation without an enclosure in washdown areas. Motion feedback is delivered by digital servo feedback with relative position detection. The drive reads this device optically, and its internal interpolation provides a positioning tolerance of ± 0.5 angular minutes. Winding code 058 matches the electrical resistance profile required by Indramat drives, and a plain shaft transmits power to the load.

The centering spigot is 130 mm, allowing precise alignment with gearboxes or machine frames, and the face provides both 140 mm and 150 mm bolt circles for mounting. Rated operation is permissible between 0 to 40 °C, while storage from -20 to +80 °C protects the windings when the machine is idle or being transported. A shaft seal is fitted to limit oil ingress at the output journal, and the motor can be used up to 1000 m above MSL. Because the motor is supplied without a holding brake, external mechanics or drive torque must secure vertical axes when power is off.