Product Description:

The Bosch Rexroth Indramat MHD095C-035-PG0-LN is a servo motor in the MHD Synchronous Motors series for tightly regulated rotary axes in automated machinery. It combines a 095 frame with the medium C housing length and mounts through a 140/150 mm flange, giving the motor a familiar mechanical interface for enclosed machine layouts. This type of motor is suited to positioning tasks that require repeatable speed and angle control during changing load conditions. Digital servo feedback is supplied by an integrated encoder, so the controller can monitor position directly without external sensors. Electrical power enters from the left side through a sealed power connector, which helps keep cable routing orderly in compact equipment.

Under stable conditions, the motor can deliver 23.0 Nm of continuous torque at standstill. Heat generated by the windings is removed by liquid cooling, which supports nominal performance in closed machine frames where airflow is limited. A sealed stator housing with an IP65 rating helps keep dust and low-pressure water jets away from internal parts, and a shaft seal adds protection for the bearings. The permitted ambient temperature range is 0 to 40 °C, and Class F insulation supports winding temperatures up to 155 °C. Rotor position is measured optically, no holding brake is fitted, and operation is permitted up to 1000 m above mean sea level. Because there is no holding brake, any power-off load retention must be provided by the driven system or by drive-applied holding torque.

The motor uses a 130 mm centering diameter to align the housing concentrically with the driven load. This centering fit helps maintain shaft alignment and reduces coupling stress during installation. Feedback accuracy is listed as ±0.5 angular-minute, and the encoder stores absolute (>4096 revolutions) travel data for multi-turn position tracking. The output uses a plain shaft, which simplifies coupling selection where no keyed connection is required. Winding code 035 matches the electrical configuration used with the 095 frame, and storage is permitted from −20 to +80 °C without harming the insulation system.