Product Description:

The MHD095C-024-PG0-AN is a servo motor produced by Bosch Rexroth Indramat within the MHD Synchronous Motors series. It operates as the electromechanical drive element in automated machining and material-handling equipment, where closed-loop speed and position control are required. Driven by a matching inverter, the unit converts three-phase electrical power into precise rotary motion for indexing tables, linear stages, and packaging axes used throughout industrial automation. When paired with Indramat digital drives, it supports repeatable motion profiles and maintains stable torque at low speeds.

For mechanical installation, the motor provides a centering diameter of 130 mm and a dual flange pattern of 140 / 150 mm, allowing direct attachment to standard IEC frames with accurate axial alignment. The frame code 095 is paired with length class C, and the housing uses liquid cooling through its jacket to remove heat during operation. Under steady-state conditions, the electromagnetic system develops 23.0 Nm of continuous standstill torque, permitting the axis to support static loads without drive derating. Because it is supplied without a holding brake, any required locking must be provided by controlled current from the servo amplifier or by an external clamping device.

Connection hardware is minimized, and three-phase power is routed through an output connector located on side A, which simplifies right-hand cabinet layouts. Rotor position is monitored by a digital servo feedback encoder that provides absolute feedback for more than 4096 revolutions, so the controller retains position after power cycling. The stator’s electrical characteristics correspond to winding code 024, enabling predictable pairing with Rexroth drive tables. A plain shaft transmits torque to the load, and a shaft seal helps prevent coolant or dust from entering the front bearing.