Product Description:

The MHD095C-024-NG0-BN servo motor is manufactured by Bosch Rexroth Indramat within the MHD Synchronous Motors series. Designed for industrial automation, the unit works with compatible drive controllers to actuate conveyors, handling robots, or tool heads that require repeatable positioning. Its frame length code C provides additional stack height over shorter models, and the 095 size suits medium-power applications in line-shaft or direct-drive layouts while maintaining a practical installation footprint.

When powered, the motor can develop a continuous standstill torque of 23.0 Nm, allowing it to hold or slowly index payloads without thermal overload. Heat generated by copper losses is removed through liquid cooling; circulating coolant keeps the stator below its Class F insulation limit and permits higher RMS current than air-cooled variants. Rotor position is reported by digital servo feedback (HSF), which supplies high-speed signals suitable for dynamic drive regulation. The enclosure carries an IP65 rating, meaning it is dust-tight and resistant to water jets so the motor can be mounted outside control cabinets. A centering pilot of 130 mm simplifies alignment on precision bearing housings and helps minimize radial runout when the motor is coupled directly to load shafts.

The mounting flange measures 140 / 150 mm, giving a wide bolt circle that distributes reaction forces during rapid reversals. Combined with an internal measurement system that resolves motion to ± 0.5 angular minutes, the motor is suitable for contouring applications that require low interpolation error. Reliable operation is maintained in ambient temperatures from 0 to 40 °C, and a shaft seal helps prevent coolant or washdown fluid from entering the bearing zone under those conditions. The electromagnetic design uses winding code 024, which corresponds to the electrical characteristics used by the matching drive for current regulation.