Product Description:

The MHD095C-024 is a servo motor built by Bosch Rexroth Indramat as part of the MHD Synchronous Motors series. It is intended for closed-loop drive axes in packaging, printing, and material-handling lines where precise speed and position regulation are required. By converting electrical input from a compatible drive controller into rotary motion, the unit provides the mechanical power needed for automated tooling, conveyors, and pick-and-place stations. The combination of permanent-magnet excitation and an electronic feedback system supports accurate control under varying loads and duty cycles. That control behavior helps the motor maintain commanded motion during start-stop cycles, indexing moves, and synchronized line operation.

At standstill, the motor can deliver a continuous torque of 23.0 Nm, giving the axis enough margin for holding tasks or low-speed milling without overheating. The centering pilot measures 130 mm, and this diameter aligns the housing concentrically with the machine frame so radial runout stays minimal. A square flange with hole patterns of 140/150 mm supports direct bolting to standard IEC mounts and reduces the need for adapter plates. The motor uses size code 095, which corresponds to the frame and stator cross-section. Length code C extends the active iron to increase continuous power while keeping the same mounting geometry at the interface.

The winding code 024 indicates the electrical configuration used with compatible Rexroth power modules. Integrated temperature sensors allow the drive to reduce output before the insulation reaches its thermal limit. The motor uses permanent-magnet excitation for efficient torque production across the operating range. A digital feedback device supplies the position information needed for accurate speed regulation and repeatable axis movement. These signals help the axis respond cleanly to changing loads during continuous production.