Product Description:

The MHD095B-035-PP1-AN is a synchronous servo motor produced by Bosch Rexroth Indramat within the MHD Synchronous Motors series. It is engineered to drive rotary axes in packaging lines, machine tools, and material-handling stations where repeatable velocity and position control are required. An absolute multi-revolution encoder is embedded so the controller always knows shaft orientation, allowing coordinated homing and quick restart after power loss. That makes the motor suitable for axes that must resume operation without a full home cycle after an interruption.

Its continuous torque at standstill is rated at 17.5 Nm, so the motor can support a steady load at zero speed during continuous operation. The enclosure carries a protection rating of IP65, which keeps out dust and resists low-pressure water jets in industrial settings. Heat generated in the stator is removed through liquid cooling, which helps keep winding temperature stable during demanding duty cycles. A permanent-magnet holding brake supplies 22.0 Nm of static torque to secure vertical loads when power is off. The brake is intended to hold the axis at rest rather than stop it dynamically during motion. Alignment during mounting is simplified by a centering pilot of 130 mm that mates with standardized machine flanges sized 140 mm or 150 mm.

System position feedback is resolved optically with a total system accuracy of ±0.5 angular minutes, helping the motor maintain precise interpolated motion. The motor operates in ambient air from 0 to 40 °C and may be stored between -20 to +80 °C when not in service. Class F insulation supports coil temperatures up to 155 °C and works with the cooling jacket during continuous use. A keyed shaft with a factory-installed seal supports direct mechanical coupling while helping keep contaminants away from the bearing area. The output connector points toward side A, and this layout can simplify cable routing where space near the rear of the motor is limited.