Product Description:

The MHD093C-058-PP1-BN is a servo motor manufactured by Bosch Rexroth Indramat for the MHD Synchronous Motors series. It delivers closed-loop motion control for positioning axes, pick-and-place stations, and other cyclic drives used in industrial automation by combining permanent-magnet excitation with an integrated digital encoder. This arrangement allows the connected drive to regulate speed, position, and holding behavior with consistent response during repeated starts and stops. That combination supports stable axis behavior in packaging, transfer, and assembly systems where motion must be both repeatable and responsive.

The motor centers on a 130 mm locating pilot that aligns the flange during installation. At standstill, it delivers 23.0 Nm of continuous torque for static load holding without overheating. The 140 / 150 mm square flange matches common gearboxes and machine frames. Heat is removed through liquid cooling, supporting higher duty cycles than air-cooled housings. A built-in brake supplies 22.0 Nm of holding torque to secure vertical loads when power is removed. The keyed shaft helps prevent rotational slip between the motor and the driven element. Digital servo feedback with an integrated encoder supplies absolute position data beyond 4,096 revolutions for precise interpolation, and power is routed through an output connector.

Within the series, this unit carries frame code 093, winding code 058, and the C length variant, which gives it a medium-size housing for servo applications with sustained demand. The power connector faces side B, which can simplify cable routing when several motors are mounted close together. A sealed output connector together with a shaft seal restricts coolant ingress into the bearing cavity during liquid-cooled operation. The integrated encoder reduces the need for repeated homing after normal shutdowns, while the brake can hold the rotor in place when the axis is not moving.