Product Description:

The MHD093C-058-PG0 servo motor produced by Bosch Rexroth Indramat belongs to the MHD Synchronous Motors series. As part of a closed-loop drive system, it supplies regulated torque and speed to machine elements in automated packaging equipment, pick-and-place robots, and light machining centers. When paired with compatible power modules and position controllers, the motor supports repeatable positioning and stable cycle timing during multi-axis motion. This type of motor is suited to applications that require accurate starts, stops, and speed changes over repeated operating cycles.

Mechanically, the motor seats against a pilot recess measuring 130 mm in diameter, which helps with coaxial alignment to gearboxes or bearing housings. Its square mounting interface follows the 140 / 150 mm flange pattern for installation on matching machine faces. Within the product range, it carries size code 093 and length class C, which indicate the frame size and motor length used for this housing. Winding code 058 identifies the stator conductor arrangement matched to the current and voltage profile of compatible Bosch Rexroth drives. Under continuous stall conditions, the rotor can deliver 23.0 Nm of torque for moderate inertia loads.

Motion is measured by a digital servo feedback system housed in the motor end bell. The encoder provides position data that is absolute (>4096 revolutions), which reduces the need for a reference run after startup. A shaft seal surrounds the plain output journal to help keep contaminants away from the bearings and retain lubricant. Because the unit is supplied without a holding brake, any static load holding must be handled by an external device or by the drive system when the application allows it. The plain shaft supports coupling-based power transmission in enclosed machine assemblies.