Product Description:

The MHD093C-035-PG2-BN is a servo motor produced by Bosch Rexroth Indramat within the MHD Synchronous Motors series. As a rotary actuator for industrial automation, the unit converts electrical energy from a drive controller into controlled mechanical rotation for positioning and speed-regulated tasks on machinery and material-handling stations. This operating role supports closed-loop motion where accurate shaft response is required during starts, stops, and speed changes.

It delivers a continuous standstill torque of 23.0 Nm, allowing stable force output while the rotor is locked but energized. The stator windings identified by code 035 set the current and voltage pairing that the associated drive must supply. The motor uses a centering diameter of 130 mm and a square flange size of 140 / 150 mm, so it mounts directly on standardized faces without adapters. Heat generated in the copper and stator iron is removed through liquid cooling; coolant channels in the housing help the motor maintain rated torque across repeated duty cycles while limiting external surface temperature. The motor has size 093 with a C-length frame, matching the installation envelope used elsewhere in the series.

The motor is equipped with a holding brake that exerts 32.0 Nm to secure the load at rest or during power loss. Position feedback is supplied by a digital encoder with absolute (>4096 revolutions) feedback, enabling the controller to recover shaft angle after shutdown without homing routines. Power cables exit through an output connector on side B, which can simplify cable routing when the motor is installed in confined spaces. A plain shaft with a shaft seal is provided to limit lubricant migration and support direct coupling with clamping hubs or shrink discs in liquid-cooled servo axes. This arrangement supports secure load holding at rest while preserving position information between operating cycles.