MHD093C-035-PG1-RN Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911287564
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat MHD093C-035-PG1-RN is a servo motor from the MHD Synchronous Motors series featuring a plain shaft design with a shaft seal and digital servo feedback with an integrated encoder for absolute position detection beyond 4096 revolutions. It is equipped with liquid cooling, a holding brake rated for 22 Nm, and provides 23 Nm continuous torque at standstill.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MHD093C-035-PG1-RN belongs to the MHD Synchronous Motors series produced by Bosch Rexroth Indramat. It is a servo motor intended for positioning and velocity control tasks in automated machinery, where compact torque density and accurate motion control are required for repeatable motion profiles. This layout suits feed axes, handling units, and similar motion systems that must accelerate, stop, and hold position with consistent response over repeated cycles.
The motor delivers a continuous standstill torque of 23.0 Nm, allowing it to hold or drive static loads without overheating. Accurate mechanical alignment is supported by a centering diameter of 130 mm, while a flange size of 140 / 150 mm matches common mounting patterns on gearboxes or machine frames. Heat is removed through liquid cooling, so the winding code 035 can sustain rated currents in thermally demanding duty cycles. Position data are supplied by digital servo feedback with an integrated encoder, enabling the drive controller to regulate torque and speed precisely. The motor size 093 identifies the frame dimensions, and length code C indicates a housing depth suited to medium-power axes. Its power cable exits to the right, and a molded connector simplifies electrical hookup while maintaining IP sealing at the housing interface. This arrangement also helps the motor fit compact installations where routing space around the drive end is limited.
A factory-installed holding brake generates 22.0 Nm of static torque, preventing axis movement during power loss or maintenance. The drive shaft uses a plain shaft, so couplings or pulleys can be mounted without keys, and a shaft seal protects internal bearings against coolant or dust ingress. Multi-turn tracking is possible because the encoder provides absolute position data for more than 4096 revolutions, eliminating the need for homing after each startup. Power enters through a single power connector, keeping installation time low and supporting consistent contact resistance over the service life. This combination supports axes that must remain secure at standstill and recover stored position information when operation resumes.
