Product Description:

The MHD093C-035-PG0-AN/S020 is a servo motor manufactured by Bosch Rexroth Indramat for the MHD Synchronous Motors series. As an electrically commutated drive, it works with digital controllers to provide rapid, closed-loop torque and speed control in automated handling equipment, conveyor sections, and forming machines. The motor has a size 093 frame with length code C, which gives it a compact footprint for machinery where space is limited. Its plain shaft allows direct coupling to gearboxes or load shafts without additional keying hardware.

The drive delivers a continuous standstill torque of 23.0 Nm, enabling constant load support without thermal overload. Its housing carries an IP65 rating, so internal windings remain sealed against dust and water jets during washdown cycles. Heat generated by the stator is removed through liquid cooling, which helps stabilize winding temperature during high-duty operation. Mechanical alignment uses a 130 mm pilot diameter and a flange with a 140 / 150 mm bolt circle. An optically measured digital servo feedback encoder supplies position data, while the power leads exit on side A through an output connector. The motor is supplied without a holding brake, uses winding code 035 for drive matching, and includes a shaft seal for added ingress protection.

Thermal performance uses insulation class F and is intended for ambient temperatures of 0 to 40 °C. Positioning accuracy reaches ± 0.5 angular minutes, which supports repeatable motion in regulated axis applications. The integrated feedback provides absolute position information over more than 4096 revolutions, so homing is not required after power is restored. The unit can be mounted up to 1000 m above mean sea level and stored between -20 °C and +80 °C, and the centered connector grouping helps keep cable routing orderly.