Product Description:

The MHD093C-035-NP1-AN is a servo motor manufactured by Bosch Rexroth Indramat as part of the MHD Synchronous Motors series. It is intended for closed-loop position and speed control on production machinery, packaging lines, and material-handling equipment where precise, repeatable motion is required. Position feedback is delivered by a digital servo feedback encoder that uses optical scanning and reports relative position to the drive controller. This arrangement allows the drive to monitor rotor movement continuously and correct speed or position deviations as operating loads change during normal machine cycles.

Mechanical alignment is simplified by a centering diameter of 130 mm, while winding code 035 matches the stator to drives that supply the correct current and voltage profile. Under locked-rotor conditions, the unit produces a continuous standstill torque of 23.0 Nm, allowing it to hold loads without overheating during low-speed or stationary operation. A sealing rating of IP65 helps prevent dust ingress and water-jet entry, and the stator jacket uses liquid cooling to keep temperature under control during full-duty cycles. The motor can operate at ambient temperatures from 0 to 40 °C and at elevations up to 1000 m above mean sea level.

The mounting flange pattern is 140 / 150 mm, and the motor uses a keyed shaft with an integral shaft seal for direct torque transmission to couplings. A spring-applied holding brake supplies 22.0 Nm of static torque for load retention when power is removed, which is useful on axes that must remain in place at standstill. Motion accuracy reaches ± 0.5 angular minutes, and windings built to insulation class F tolerate internal temperatures up to 155 °C. The motor has length code C and frame size 093, and power leads exit toward side A through an output connector that simplifies wiring. For long-term storage, the unit may be kept from -20 to +80 °C without degrading magnetic or insulation properties.