Product Description:

The MHD093C-024-NP0-AA is a servo motor built by Bosch Rexroth Indramat for the MHD Synchronous Motors series. With winding code 024, length code C, and a 093 frame, the unit provides controlled rotary power to conveyors, pick-and-place arms, and tooling stations that demand accurate speed and position regulation in industrial automation. The design omits a holding brake to reduce inertia on axes where drive torque provides position retention.

It develops a continuous standstill torque of 23.0 Nm through a keyed shaft, and a centering diameter of 130 mm aligns the 140/150 mm flange to couplings. The aluminum housing carries an IP65 rating, and heat is removed by natural convection, avoiding forced-air hardware. Rotor angle and velocity are read through Digital servo feedback (HSF), which uses optical sensing and delivers relative position data with ±0.5 angular-minute system accuracy. Power leads exit on side A via an output connector, and a factory-installed shaft seal keeps lubricant inside and contaminants outside during continuous duty. Because the connection hardware is located on the motor face that points away from the machine frame, power lines can be disconnected without disturbing the mechanical alignment. The keyed interface transmits torque reliably with minimal backlash, supporting cyclic forward-reverse profiles common in pick-and-place axes.

The motor has separate storage and operating temperature limits. Non-energized equipment may be held between -20 to +80 °C, while rated performance is maintained from 0 to 40 °C. Class F insulation withstands high winding temperatures, and installation is cleared for up to 1000 m elevation without derating. These limits support use in typical industrial environments where stable thermal performance and consistent positioning are required.