Product Description:

The MHD093C-024-NG0-BN is a three-phase servo motor produced by Bosch Rexroth Indramat in the MHD Synchronous Motors series. It converts drive controller commands into controlled rotational motion for closed-loop positioning on material-handling equipment, packaging axes, and other automation systems. It is suitable for synchronized motion tasks in conveyors, indexing units, and handling modules where the drive must respond quickly to changing commands. The motor is intended for applications that require precise speed control, stable torque response, and repeatable axis movement.

At the core of its performance profile is a continuous standstill torque of 23.0 Nm, allowing the rotor to hold static loads without overheating. Protection is rated at IP65, so the housing blocks dust ingress and low-pressure water jets, enabling mounting close to machinery. Heat generated by the windings is removed through liquid cooling, which helps keep stator temperature low and supports insulation class F service life. Position feedback is supplied by digital servo feedback (HSF) with optical scanning for high-resolution rotor angle data. Combined with a system accuracy of ± 0.5 angular minutes, the motor supports precise contouring and repeatable start-stop cycles in multi-axis lines.

For mechanical integration, the flange pattern measures 140 / 150 mm, and a centering diameter of 130 mm aligns the motor to the machine frame without radial play. The plain shaft and shaft seal support coupling to gearboxes, while the power connector on side B can simplify cable routing where space is limited. The shaft seal also helps limit contaminant entry around the bearing area in wet or dusty machine zones. Because the motor is delivered without a holding brake, vertical axes must rely on external clamping devices or drive torque during power loss. Environmental limits span an operating range of 0 to 40 °C and a storage range of −20 to +80 °C, and installation is permitted up to 1000 m above sea level. The motor uses relative position detection, winding code 024, and length code C.