Product Description:

The MHD093C-024-NG0-BA is a servo motor produced by Bosch Rexroth Indramat and supplied within the MHD Synchronous Motors series. As an electromechanical drive component, it converts controlled electrical power into rotary motion for positioning, indexing, and speed-regulated tasks on packaging machines, handling axes, and general automation lines. The motor forms part of closed-loop drive systems, where its feedback interface lets a drive controller compare commanded and actual shaft positions so that production processes stay synchronized. This arrangement supports repeatable motion in applications where axis timing and position tracking must remain consistent during continuous operation.

The motor has a centering pilot of 130 mm, allowing direct seating in machine frames with minimal radial play, while the square mounting face supports flanges of 140 / 150 mm to match standard gearbox and machine interfaces. At standstill, the stator delivers 23.0 Nm of continuous torque for clamping or slow feed movements without overheating. Heat leaves the housing by natural convection, so ambient airflow must be available instead of forced cooling. A built-in shaft seal helps block contaminant ingress at the output end, and because the unit is supplied without a holding brake, static loads must be secured by external means. The 024 winding code corresponds to the electrical values expected by the matching drive.

Motion data is captured through Digital servo feedback (HSF), which sends high-resolution rotor position information to the drive. Because the signal is incremental, the system treats position measurement as relative and homes the axis after power-up before absolute positioning begins. The body length code C accommodates this feedback system, the 024 stator winding, and the rotor within the mid-range 093 frame. Power exits through a connector on side B, which can simplify cable routing in compact machine layouts. Torque reaches the load through a plain shaft with no keyway, which reduces stress concentrations and supports shrink-fit coupling.