Product Description:

The MHD093B-035-PP0-BN is a servo motor produced by Bosch Rexroth Indramat as part of the MHD Synchronous Motors series. It converts command signals from a drive controller into controlled rotary motion for indexing tables, packaging axes, and other industrial automation tasks. By combining electrical commutation with precise mechanical alignment, the unit supplies dependable speed and torque regulation wherever compact synchronous motors are required on the plant floor.

It delivers a continuous standstill torque of 17.5 Nm, allowing heavy loads to remain stationary without thermal overload. Heat generated in the windings is removed through liquid cooling, so the housing can maintain rated output even during prolonged duty cycles. Protection against dust ingress and water jets is certified to IP65, extending service life in wash-down areas. The centering pilot measures 130 mm, and the flange pattern aligns with 140 / 150 mm mounting holes. A keyed shaft with a fitted shaft seal transfers power while helping block lubricant migration. The motor operates reliably in ambient temperatures from 0 to 40 °C, and it is supplied without a holding brake, so external clamping devices must secure vertical axes. Power enters through a connector on side B, simplifying cable routing inside compact enclosures.

Position feedback is delivered by a digital servo encoder that is evaluated optically. This device supplies absolute feedback for more than 4096 revolutions, so homing routines are unnecessary after power loss, and combined system accuracy reaches ± 0.5 angular minutes for fine alignment tasks. The internal winding set carries designation 035, and its insulation is rated to class F, supporting winding temperatures up to 155 °C. Size 093 geometry with motor length code B keeps the package compact while maintaining thermal mass for the cooled housing. Installations may be placed up to 1000 m above mean sea level without derating, and units can be stored between -20 °C and +80 °C until deployment.