Product Description:

The MHD093A-035-NP1-AA is a servo motor produced by Bosch Rexroth Indramat for the MHD Synchronous Motors series. It integrates into drive systems that need closed-loop positional control on packaging lines, printing presses, and material-handling axes. The motor uses natural convection through its aluminum housing and relies on digital servo feedback for high-speed control loops. This combination supports precise electronic gearing between axes and stable response during repeated indexing moves.

At standstill, the motor can deliver a continuous torque of 12.0 Nm, making it suitable for holding payloads without overheating. The enclosure meets IP65, which helps keep out dust and resist low-pressure water jets on the factory floor. Servo accuracy is maintained within ± 0.5 angular minutes when the motor is used with its high-speed feedback (HSF) encoder and relative position detection method. Reliable service is supported across an operating ambient range of 0 to 40 °C; outside this window, derating or external cooling would be required. Power is cabled to side A through an output connector, and the keyed shaft transmits motion without relying on shrink-fit couplings.

The built-in holding brake secures loads with 22.0 Nm of static torque during power-off states. A centering flange of 130 mm aligns the housing to gearboxes or adapter plates, while the square mounting pattern accepts bolts on 140 / 150 mm centers. During shipment or extended stops, the unit may be stored between -20 to +80 °C without loss of insulation integrity, and the windings are rated to Class F for continuous thermal endurance. Installation is permitted up to 1000 m above mean sea level. The motor size 093, motor length A, and winding code 035 identify the electrical and mechanical combination, and a shaft seal protects the internal bearings from coolant splash.