Product Description:

The MHD093A-035-NP0-BA servo motor is manufactured by Bosch Rexroth Indramat and belongs to the MHD Synchronous Motors series. As a rotary actuator, it pairs with digital drive controllers to provide accurate motion within automated equipment. Electrical feedback helps the system maintain commanded position and velocity across its temperature and installation limits.

During operation, the motor delivers a continuous standstill torque of 12.0 Nm, enabling static load holding without overheating. Its mounting interface uses a 140/150 mm square flange for secure installation. The enclosure is rated IP65, helping protect internal components from dust and water jets when the ambient temperature remains within 0 to 40 °C. Position feedback reaches the drive with accuracy held within ± 0.5 angular minutes, which supports precise motion control. A keyed shaft transfers torque directly, and power conductors exit through a connector on side B for straightforward cable routing.

For storage or transportation, the unit withstands temperatures from -20 to +80 °C without loss of insulation integrity, and insulation class F supports the permitted winding temperature. Heat generated in service is removed through natural convection, so no forced airflow is required when the installation height stays below 1000 m above mean sea level. The Digital servo feedback (HSF) encoder uses an optical measurement method to supply relative position data to the controller, and the motor is matched to winding code 035. An internal shaft seal is present, and the motor is supplied without a holding brake for systems that use external clamps or drive torque to maintain position. The motor also has a 130 mm centering diameter, size 093, and a compact A-length housing that keeps mass low while preserving alignment accuracy.