MHD093A-024 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
- Straightforward Pricing: No Rush Fees, No Credit Card Fees
Current response time:
3 Minutes
20 Seconds
The Bosch Rexroth Indramat MHD093A-024 is a servo motor from the MHD Synchronous Motors series. It features a centering diameter of 130 mm and a continuous torque at standstill of 12.0 Nm. The motor has a flange size of 140 or 150 mm and is identified by motor size 093 with winding code 024.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MHD093A-024 is a permanent-magnet synchronous servo motor produced by Bosch Rexroth Indramat and supplied as part of the MHD Synchronous Motors series. As a servo motor, it converts controlled electrical power from an Indramat drive into angular motion that supports positioning and velocity loops in automated machinery, including packaging axes, gantry drives, and material-handling stations. Its size and flange pattern allow direct mounting to gearheads or machine frames, while the low-inertia rotor enables fast response to command changes issued by the drive controller. This operating behavior is useful on axes that require quick starts, controlled stops, and stable motion during changing load conditions.
The centering land measures 130 mm, ensuring concentric alignment between the motor and driven equipment while reducing shaft runout. A square flange footprint of 140 / 150 mm provides two standardized bolt circles so the housing can adapt to different machine plates without adapters. When the stator windings are energized at rated current, the motor sustains 12.0 Nm of continuous standstill torque, supplying stable holding force for vertical loads or static pressing applications. Frame designation 093 identifies the stator stack diameter, while the compact length code A keeps overall mass low to minimize reflected inertia. These dimensions also help the motor fit installations where mounting space is limited but accurate alignment remains important.
Electrical characteristics are set by winding code 024, which corresponds to the resistance, inductance, and voltage constant expected by the connected drive amplifier. Identified as a Servo Motor, the unit is intended for closed-loop position and velocity control rather than open-loop speed regulation. Within the MHD Synchronous Motors range, this frame and length combination supports compact machine layouts and responsive axis performance. Across multiple axes, the motor can provide repeatable dynamic response when it is matched with the proper drive, feedback setup, and mechanical load.
Frequently Asked Questions about MHD093A-024:
Q: What is the continuous torque at standstill for the MHD093A-024 motor?
A: The continuous torque at standstill for the MHD093A-024 servo motor is 12.0 Nm.
Q: What is the centering diameter of the MHD093A-024 motor?
A: This model features a centering diameter of 130 mm for precise alignment during installation.
Q: What flange sizes are available for the MHD093A-024 motor?
A: The MHD093A-024 motor is produced with a flange size of either 140 mm or 150 mm.
Q: What is the designated motor length of the MHD093A-024 model?
A: The MHD093A-024 motor has a motor length specified as type 'A'.
Q: What is the motor size classification for the MHD093A-024 model?
A: This motor is identified as size 093 within the MHD Synchronous Motors series.
