Product Description:

The MAC112D-0-ED-2-C/130-A-2/S013 is an AC servo motor produced by Bosch Rexroth Indramat and supplied within the MAC AC Servo Motors series. Designed for analog drive controllers, the unit delivers rotary motion that translates command voltages into synchronized shaft rotation for positioning and speed-controlled motion. Its frame follows the 112 size code and a D-length stator stack, giving a balanced mix of torque density and installation depth suitable for packaging lines, material-handling axes, and other general-purpose automation stations. Integrated speed feedback allows the connected controller to monitor motor response during changing load conditions.

Mechanical holding force is provided by a heavy-duty blocking brake. This integrated brake can sustain static loads without continuous power, and it is suited to axes that must remain fixed during stops. The brake exerts 60 Nm of torque, allowing vertical or intermittent-duty axes to stay locked during power loss. Accurate mechanical alignment is aided by a 130 mm centering diameter, which mates the front flange to standard mounting pilot registers. Heat is removed through natural convection, so no external blower or liquid circuit is necessary. Rotor speed feedback is supplied through tacho feedback, enabling the analog drive to read real-time velocity for closed-loop control.

Continuous running characteristics are tuned by the ED winding set, and at rated excitation the motor reaches 3000 rpm while maintaining stable torque and moderate armature current. The three-phase power leads exit through a connector on side A, positioning wiring away from adjacent axes in compact cabinets. For velocity scaling, the tacho generator outputs 3 V/1000 rpm, and its standard signal quality fits most analog regulators. The winding code also corresponds to the electrical values used by compatible drive modules, while the D-length stack helps balance inertia and acceleration during repeated indexing cycles.