Product Description:

The MAC112D-0-ED-1-C/130-A-0/S05/J625 is an AC servo motor produced by Bosch Rexroth Indramat within the MAC AC Servo Motors series. It is intended for use in automated machinery that relies on precise speed and position control when paired with analog drive amplifiers. By converting commanded current into controlled mechanical rotation, the motor supplies closed-loop actuation for indexing tables, packaging axes, or material-handling gantries in industrial environments. This arrangement supports repeatable motion in systems that use analog command structures and separate feedback channels.

Heat produced by the stator windings is removed through natural convection, so the unit can be installed without external blowers or liquid circuits. A centering diameter of 130 mm aligns the housing in standard mounting recesses, while frame code 112 corresponds to the flange size and shaft height used by compatible gearboxes. Position feedback is provided by incremental encoder feedback, allowing the connected drive to close a high-resolution velocity loop at a rated speed of 3000 rpm. Power conductors and protective earth are brought in through a plug situated on the stator by a connector on side A, which simplifies routing inside a control cabinet and helps prevent cable strain on moving axes.

The motor has no holding brake, so any load-holding requirement must be met with external clamping hardware or drive torque when the system is disabled. The internal wiring follows length code D, indicating a rotor-stack depth that balances inertia against continuous torque output. A standard analog tacho generator delivers 3 V/1000 rpm, enabling legacy controllers to verify speed even if the encoder channel is unavailable. Winding code ED identifies the conductor cross-section and coil pitch selected for medium-voltage operation, and the motor is classified as a product for analog drives rather than fully digital interfaces.