MAC112B-1-LD-4-C/130-A-1/WA612XX
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911227479
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
MAC Permanent Magnet Motor manufactured by Bosch Rexroth Indramat. This motor has a power connecter on Side A. This motor also includes a B encoder and a Standard blocking brake.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
MAC112B-1-LD-4-C/130-A-1/WA612XX is an AC servo motor. It is manufactured by Bosch Rexroth. MAC motors are optimized for industrial use. Typical applications include transfer facilities, robotics, packaging and textile. Permanent magnets are used for motor construction. Electronic commutation improves motor reliability and safety. Tacho feedback on MAC motors provides accurate speed and position feedback. These motors allow maintenance-free operation, which is enabled by the brushless design and use of life-time lubricated bearings. IP65 compliant housings provide full dust ingress protection and robust water ingress protection. As a result, MAC motors can be safely used in a wide range of operating environments. MAC112B-1-LD-4-C/130-A-1/WA612XX is a MAC motor with a plain shaft. It supports surface cooling. A factory-installed axial cooling fan dissipates heat generated during operation. This fan requires 230 Volts AC power supply.
For rated output, the ambient temperature should be between 0 and 45 degrees Celsius, and the site altitude should be between 0 and 1000 meters. With surface cooling, the continuous torque output at standstill is 29 Amps. The continuous current output at standstill is 43.5 Amps. Thermal time constant of the motor is 60 minutes. The motor weighs approximately 36 kilograms. Its speed rating is 2000 RPM. The motor is equipped with a standard blocking brake. This is a safety device designed to prevent accidental motor shaft movement. Holding torque of the brake is 45 Nm. A 24 Volts DC electrical release signal is required for shaft release. This release signal is sent by the motor controller used to control motor operation. Weight of the blocking brake is 1.1 kilograms. Its release delay is 70 milliseconds and its clamping delay is 30 milliseconds.
