MAC112B-0-LD-2-C/130-A-1/S008
Wake Industrial LLC is not an authorized distributor of this product.
MPN: R911225868
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
MAC Permanent Magnet Motor manufactured by Bosch Rexroth Indramat. This motor has a power connecter on Side A. This motor also includes a B encoder and a Standard blocking brake.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MAC112B-0-LD-2-C/130-A-1/S008 AC servomotor manufactured by Bosch Rexroth is compatible with the manufacturer's DSC, KDS, or TDM drive controller. This servomotor is excited by permanent magnets with electronic commutation. The product uses an encoder to evaluate its position. This device deploys a simple process for mounting onto the associated machine. The unit encounters a defined assimilation of external forces at the shaft. It is delivered with a standard holding brake. The motor comprises a standard windings design.This product encompasses a mounting flange with a standard pilot diameter. This device supports a maximum installation altitude of 5000 m above sea level. The unit is protected against the penetration of water. It can be mounted in horizontal or vertical mounting orientation according to DIN IEC 34-7 specifications. This motor has a tacho voltage that matches its nominal speed. The product is always equipped with a shaft sealing on its output shaft.
This device is affected by thermal deformations in length when it is in use. The unit relies on natural convection cooling mode. Its holding brake is controlled by a PLC or a hardware switch.This motor should be run at approximately 100 rpm speed as part of the grind-in process after the storage period. The product is delivered with the output direction of the electrical connector to the A side. This device includes the connecting cable for the holding brake in its power cable. The unit comprises a 12-pin flanged socket for its encoder and feedback connections. Its holding brake has a holding torque of 45 Nm. The AC servomotor must be wired as per the terminal diagram of the machine manufacturer.
