Product Description:

The MAC093C-0-CS-4-C/110-A-0/WI520LV/S001 is an AC servo motor manufactured by Bosch Rexroth Indramat for the MAC AC Servo Motors series. Intended for analog drive controllers, it converts current command signals into controlled torque and speed for production lines, pick-and-place equipment, and light spindle applications. Its permanent-magnet rotor, laminated stator, and integrated feedback hardware allow automation systems to position loads quickly while maintaining accuracy throughout continuous-duty cycles.

A centering pilot of 110 mm aligns the stator with gearboxes or adapters, while the motor has size code 093 and a corresponding flange footprint. The motor has length C, which provides moderate continuous torque without adding unnecessary mass. Heat is removed through natural convection, so continuous airflow is not required and enclosure design remains simple. The rotor operates at a nominal speed of 6000 rpm, making it suitable for high-speed spindle applications. Winding code CS indicates the electrical arrangement used for the stator windings. Phase conductors reach the drive through a connector on side A, allowing the power cables to exit the housing in the same direction as the feedback cable. This cable orientation can simplify routing when nearby machine components limit the available installation space.

Velocity data come from a tachogenerator that produces 1.5 V/1000 rpm. The tachogenerator uses a standard quality grade to maintain consistent linearity across the motor’s operating speed range. Position information is supplied by an incremental encoder with standard mounting, which provides the drive controller with the signals needed for accurate motion control. The motor has no blocking brake, so the drive or an external mechanical device must provide holding torque when power is removed. This arrangement requires the connected machine to account for stationary loads that could move when the motor is not energized.