Product Description:

The MAC092B-0-QD-3-C/095-A-2/S018 is an AC servo motor produced by Bosch Rexroth Indramat as part of the MAC product line. It is supplied for use with analog drives in closed-loop positioning and velocity control on transfer lines, packaging systems, and general automation cells. The motor converts amplified command signals into rotary motion while supporting stable speed and position control during repeated machine cycles. Its mechanical and electrical interfaces follow MAC platform conventions, which helps it fit established automation layouts without added interface hardware.

A factory-mounted heavy-duty blocking brake secures vertical or high-inertia loads whenever the drive is disabled, removing the need for an external clamp. Shaft alignment during installation is handled by a 95 mm centering diameter that mates with standard IEC flanges, which helps seat the housing accurately on the machine face. Heat generated in the stator windings is dissipated by natural convection, eliminating fans and reducing maintenance points. Mains and phase conductors reach the stator through a plug-style power interface placed as a connector on side A, which keeps cable routing on the same end as many legacy MAC motors.

Position feedback is provided with tacho feedback and a second shaft end, allowing the drive to monitor actual speed through the tacho generator while an encoder or coupling can be fitted to the auxiliary stub. The commutation sensor inside the tacho housing is built to standard tacho quality, providing the signal consistency needed for analog velocity loops. Because it is a motor for analog drives, its signal levels, resolver phasing, and brake coil voltage align with earlier Indramat drive cards. Within the MAC AC Servo Motors range, this configuration is used on mid-frame applications that need brake-assisted holding, stable thermal behavior, and straightforward wiring.