Product Description:

The MAC090C-1-GD-2-C/110-A-1/S005 is an AC servo motor produced by Bosch Rexroth Indramat and assigned to the MAC AC Servo Motors series. Within automated manufacturing cells, this motor supplies precisely regulated torque and speed so rotary axes follow command profiles from analog drive amplifiers. Its electromechanical design allows the actuator to integrate into gantries, packaging lines, and material-handling equipment where positional accuracy and repeatable velocity are critical, while the housing and connector layout are sized for mid-frame machinery to balance output capacity and compact installation.

Thermal management is handled by axial surface cooling, a method that draws ambient air along the stator jacket to remove heat without liquid circuits. To operate the blower, the motor uses AC 230 V, matching common plant utility voltage and simplifying wiring. During machine stoppages, a built-in blocking brake clamps the shaft to help prevent back-driving of suspended or driven loads until drive power is restored. Accurate mechanical alignment is aided by the 110 mm centering diameter on the flange, allowing repeatable seating against matched pilot recesses. For velocity feedback, the unit employs tacho feedback, producing an analog signal proportional to speed for legacy controller loops.

All electrical power conductors leave through a connector on side A, so cable routing can follow a single service loop and stay clear of moving tooling. The motor is described as a motor for analog drives, indicating that its voltage and feedback interfaces are tailored for non-digital amplifiers that rely on continuous control signals. A laminated stack wound to the GD code sets the torque constant and current rating. The motor has standard tacho quality, so speed ripple and linearity remain within general-purpose automation tolerances.