MAC090C-0-KD-3-C/110-L-1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat MAC090C-0-KD-3-C/110-L-1 is part of the MAC AC Servo Motors series and features natural convection cooling with a centering diameter of 110 millimeters. It is a motor for analog drives, equipped with tachofeedback, a second shaft end, and operates at a nominal speed of 1500 RPM.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MAC090C-0-KD-3-C/110-L-1 is a servo motor manufactured by Bosch Rexroth Indramat for the MAC AC Servo Motors series. The unit is intended to drive industrial axes that rely on analog velocity and torque loops, providing consistent rotary output for machine tools, packaging lines, and material-handling equipment. By combining a permanent-magnet rotor with sinusoidal stator excitation, the motor converts electrical power from a matched drive into controlled mechanical motion while supporting accurate closed-loop operation through its integrated feedback arrangement.
The KD winding identifies the motor’s electrical impedance and thermal behavior so the connected converter can respond correctly under changing load conditions. A nominal speed of 1500 rpm is the synchronous operating point, allowing gear ratios to be selected for moderate linear feed rates without overspeeding the armature. Heat produced in the stator is removed by natural convection, which eliminates the need for external blowers and keeps installation requirements simple. Mounting surfaces are referenced by a 110 mm centering diameter, which helps maintain concentric alignment with flange couplings or planetary gearboxes. A built-in blocking brake holds the shaft when power is off, helping prevent unwanted axis movement during stops.
Position and velocity data are derived from a shaft-mounted sensor set that provides tacho feedback with a second shaft end, giving the drive electrical speed information and a mechanical interface for external devices. The tacho generator outputs 3 V/1000 rpm, a signal level that suits the analog inputs used by legacy MAC controllers and supports stable speed regulation across the operating range. Power conductors enter through a connector on the left side, which simplifies wiring when several motors are installed in parallel rows. Its designation as a motor for analog drives indicates compatibility with systems that regulate motion through analog control methods rather than high-speed digital communication.
Frequently Asked Questions about MAC090C-0-KD-3-C/110-L-1:
Q: Does the MAC090C-0-KD-3-C/110-L-1 servo motor come with a blocking brake?
A: This model features a standard blocking brake for secure holding during operation.
Q: What cooling method is used in the MAC090C-0-KD-3-C/110-L-1 servo motor?
A: The MAC090C-0-KD-3-C/110-L-1 is equipped with natural convection cooling and does not require forced air or liquid cooling systems.
Q: What feedback configuration is present on the MAC090C-0-KD-3-C/110-L-1?
A: This servo motor provides feedback via tachofeedback and a second shaft end, supporting accurate speed monitoring.
Q: What is the nominal speed of the MAC090C-0-KD-3-C/110-L-1 motor?
A: The nominal speed of this model is rated at 1500 revolutions per minute.
Q: Where is the power connection located on the MAC090C-0-KD-3-C/110-L-1 servo motor?
A: The power connector is oriented to the left side to facilitate electrical connections.
