Product Description:

The MAC071C-0-US-2-C/095-B-0/S001 belongs to the MAC AC Servo Motors series manufactured by Bosch Rexroth Indramat. This motor is intended for analog drive systems, where it converts command voltages into precisely regulated rotary motion for positioning tables, packaging axes, or material-handling equipment. Its electromechanical layout follows the series' standardized mounting geometry, which helps it fit common servo installations while maintaining accurate shaft alignment and predictable coupling placement at the machine interface. That format suits automated equipment that depends on repeatable rotary motion during frequent starts, stops, and speed changes.

Inside the stator, winding code US identifies the coil resistance and inductance used by the connected drive for stable current delivery. The rotor is designed for a nominal speed of 2000 rpm, supporting steady operation in mid-range velocity zones common to indexing and feed tasks. A centering diameter of 95 mm aligns the flange accurately with gearboxes or adapter plates and helps limit radial runout. Heat produced by copper loss is removed through natural convection, eliminating the need for auxiliary fans and allowing installation where extra cooling hardware is not desired. Velocity feedback is provided by a tachogenerator that outputs 3 V/1000 rpm, giving the drive an analog speed signal that scales linearly with shaft rotation. This helps the control loop respond smoothly to load changes during speed regulation.

The housing uses motor length code C and size code 071, giving the unit a compact stack length for narrow machine spaces while preserving the torque capacity expected from this frame. Power conductors exit through a connector on side B, allowing the cable to route away from nearby moving parts and reducing interference with adjacent hardware. This layout is useful where surrounding machine guards or carriages limit cable clearance. The motor is supplied without a blocking brake, so the shaft can coast when drive power is removed and any holding function must come from the application.