Product Description:

The MAC071C-0-NS-2-C/095-A-0/S001 is an AC servo motor produced by Bosch Rexroth Indramat for the MAC AC Servo Motors series. Intended for analog drives, it translates voltage commands from classic servo amplifiers into controlled rotary motion that keeps industrial tooling, pick-and-place heads, or small conveyor sections synchronized with overall machine cycles. Rotor position and speed are returned to the drive through tacho feedback, enabling tight analog speed loops without digital encoders. This arrangement supports steady operation in compact motion axes that need repeatable response from a traditional servo system.

This model seats on a flange with a centering diameter of 95 mm, which serves as its mechanical reference during installation. Heat is removed by natural convection, eliminating the need for external blowers or liquid circuits and allowing cabinet layouts to stay compact. Under rated supply conditions, the shaft reaches a nominal speed of 3000 rpm, giving medium-inertia loads enough velocity range for indexing or continuous-duty tasks. The internal tacho generator provides a calibration slope of 3 V/1000 rpm, so a 9 V signal corresponds to roughly 3000 rpm. A blocking brake is not present, so static holding torque must come from the drive or an external brake if the load must remain secured when power is off.

The physical envelope is categorized as length code C within motor size 071, keeping mass and moment of inertia low for rapid acceleration. Power and feedback leads exit through a connector on side A, letting builders route cables along a single machine wall and maintain clear service access on the opposite face. The stator uses winding code NS, which indicates the electromagnetic constants expected by the matching analog amplifier. The tacho quality is standard for the response accuracy required in general-purpose automation applications.