Product Description:

The MAC071B-0-TS-2-C/095-A-1/S001 is an AC servo motor manufactured by Bosch Rexroth Indramat and placed in the MAC AC Servo Motors series. Intended for use with analog drive controllers, it translates current-loop commands into controlled shaft movement for material handling, packaging, and assembly stations. Integrated sensing and commutation allow the unit to deliver repeatable motion profiles that industrial automation cells rely on for synchronized positioning. Because feedback and commutation are built in, the matching amplifier can monitor shaft behavior continuously during acceleration and deceleration.

It carries a blocking brake able to hold a stationary load with 3 Nm of torque, keeping vertical axes secure whenever power is removed. Heat produced during operation is removed by natural convection, so no external fans are required. A centering flange diameter of 95 mm eases mechanical alignment, and this mounting geometry helps the motor fit common servo axis layouts without added alignment adapters. The built-in tacho feedback device returns continuous speed data to the controller. Under command, it reaches a nominal speed of 3000 min⁻¹, matching the dynamic range needed in mid-frame handling systems. Mains power enters through a connector on side A, keeping cable runs consistent across grouped installations. The tacho circuit follows a standard accuracy class and provides stable feedback during normal operation.

The housing uses motor length code B and frame designation 071, which match the standard dimensions of this motor format. For velocity sensing, the tachogenerator produces 3 V/1000 min⁻¹, allowing direct scaling in the analog drive. This feedback arrangement supports steady low-speed regulation and smooth transitions between commanded speed changes. The TS winding code is intended for responsive current buildup while keeping operation within the normal thermal range of the motor.