Product Description:

The MAC071A-0-TS-2-C/095-B-0/S001 is an AC servo motor produced by Bosch Rexroth Indramat within the MAC AC Servo Motors series. As a motor for analog drives, it converts command voltages from legacy control amplifiers into precise shaft torque and speed for closed-loop positioning in industrial machinery such as indexing tables, feeders, and small gantry axes. Its mechanical interface and feedback arrangement match standard MAC mounting patterns used in factory automation. This layout is also useful in retrofit equipment that still relies on analog servo electronics rather than newer networked drive platforms.

The motor seats against a pilot with a centering diameter of 95 mm, giving a repeatable reference surface for flange mounting. Frame size 071 indicates the outer stator size and supports compatibility with matching machine plates or gearbox interfaces. The rotor stack has an A length, which balances continuous torque with reduced mass for dynamic duty cycles. Heat is removed through natural convection, so operation depends on unobstructed ambient airflow instead of forced cooling accessories. Rotor behavior is monitored through integrated tacho feedback, allowing the analog drive electronics to stabilize speed during changing load conditions. This combination works well on medium-inertia axes in packaging and material handling systems.

Power conductors exit through a connector on side B, which helps keep cable bends clear of the driven shaft and improves rear access during installation. The motor is supplied without a blocking brake, so vertical or suspended loads require external holding force when the axis is stopped. It uses standard tacho quality, providing predictable voltage-per-rpm characteristics for legacy controllers that depend on analog speed signals. The electromagnetic design corresponds to the TS winding, which gives the resistance and inductance values expected by matching analog amplifiers. This winding selection helps the motor respond in a stable and consistent way when paired with the intended drive hardware.