MAC071A-0-ES-2-C/095-A-1 Bosch Rexroth Indramat
Wake Industrial LLC is not an authorized distributor of this product.
No Tariffs On US Orders- Straightforward Pricing: No Rush Fees, No Credit Card Fees
The Bosch Rexroth Indramat MAC071A-0-ES-2-C/095-A-1 is a motor for analog drives and is part of the MAC AC Servo Motors series. This motor features a standard blocking brake with a torque of 3 Nm, a 95 mm centering diameter, and a nominal speed of 4000 RPM. It is cooled by natural convection and includes tachofeedback for feedback configuration.
To contact sales for pricing and lead time:
Payment Methods
Shipping Methods
Our Credentials
Product Description:
The MAC071A-0-ES-2-C/095-A-1 is an AC servo motor produced by Bosch Rexroth Indramat for the MAC AC Servo Motors series. It serves analog drive systems by converting ±10 V commands into torque and speed for positioning or speed-regulated axes in automated equipment. The form factor follows the series flange pattern, so it fits the established mounting style used across the product line. Typical applications include indexing tables, textile winders, and small pick-and-place stages where repeatable motion and quick response are required. The motor is also suited to compact axis systems that need steady low-speed control and predictable stopping behavior during repetitive motion cycles.
Heat is removed through natural convection, so ambient airflow around the housing is sufficient to maintain operating temperature under rated load. A blocking brake provides 3 Nm of holding torque and secures the shaft whenever mains power or control voltage is absent. Precise alignment is achieved with a 95 mm centering diameter that registers the motor concentrically in the machine frame. The shaft can reach a nominal speed of 4000 rpm, supporting fast cycle times while staying within the thermal limits of this cooling method. Integrated tacho feedback supports closed-loop velocity regulation and provides an analog speed signal that is compatible with legacy servo amplifiers.
Incoming power is wired through a single plug located at a connector on side A, allowing the cable to exit in the same direction as other axis hardware for simplified routing. The internal tachogenerator outputs 1.5 V/1000 rpm, giving the drive a linear voltage proportional to rotor speed for stable velocity control. Frame size 071 identifies the exterior dimensions and bolt circle used for this motor size. Winding code ES identifies the coil pitch and conductor profile used for the motor’s electrical characteristics. This combination is appropriate for analog amplifier setups that rely on established resistance and inductance values during operation.
Frequently Asked Questions about MAC071A-0-ES-2-C/095-A-1:
Q: Does the MAC071A-0-ES-2-C/095-A-1 motor come with a blocking brake?
A: This servo motor includes a standard blocking brake, providing holding capability during power-off states.
Q: What is the blocking brake torque of the MAC071A-0-ES-2-C/095-A-1?
A: The MAC071A-0-ES-2-C/095-A-1 has a blocking brake torque of 3 Nm, ideal for securing moderate loads when the motor is not powered.
Q: How is the MAC071A-0-ES-2-C/095-A-1 servo motor cooled?
A: This model uses natural convection cooling, operating efficiently without the need for forced air or water cooling systems.
Q: What feedback configuration does the MAC071A-0-ES-2-C/095-A-1 motor use?
A: Tachofeedback is included as the feedback configuration on the MAC071A-0-ES-2-C/095-A-1, facilitating speed and position monitoring.
Q: Where is the power connection located on the MAC071A-0-ES-2-C/095-A-1?
A: The connector for power is located on side A of the MAC071A-0-ES-2-C/095-A-1 motor.
