Product Description:

The MAC063D-0-JS-2-C/095-B-1/S001 servo motor is produced by Bosch Rexroth Indramat for the MAC AC Servo Motors series. As a motor intended for analog drives, it converts command voltages from classic drive amplifiers into precise mechanical rotation in automated production equipment. The unit belongs to a range widely installed on pick-and-place axes, packaging lines, and light machining centers where accurate speed and position regulation are required. This compact rotating actuator integrates into closed-loop control systems and delivers rapid response for indexing tables and small conveyor sections. Its operating concept allows the connected amplifier to correct motion deviations as load conditions change during normal machine cycles.

A blocking brake rated at 3 Nm holds the shaft when power is removed, helping prevent load drift on vertical axes. Precise centering against gearboxes or couplings is aided by a 95 mm centering diameter that aligns the stator housing. Heat is dissipated through natural convection, so airflow around the housing must not be obstructed during operation. Under nominal drive voltage, the rotor reaches 3500 min⁻¹, a speed suited to analog velocity loops. Integrated tachogenerator feedback produces 1.5 V/1000 min⁻¹, giving the amplifier a proportional signal for continuous speed regulation. This feedback arrangement supports stable speed control across the motor’s operating range.

The power leads exit through a connector on side B, letting cables be routed away from moving machine elements. This arrangement can be useful where rear cable space is limited or where the motor sits close to guards and slides. Winding code JS indicates the electrical values expected by the analog drive, while length code D provides the magnetic volume needed without increasing the footprint. The motor uses frame size 063, which helps keep inertia low for fast acceleration.