Product Description:

The MAC063D-0-FS-4-C/095-B-1/WI517LV is an AC servo motor manufactured by Bosch Rexroth Indramat within the MAC AC Servo Motors series. It is intended for use with analog drive amplifiers, where it converts current commands into controlled rotary motion for automated assembly stations, printing units, and packaging equipment. In these systems, the motor provides repeatable torque response for axes that must accelerate, reverse, and stop smoothly during normal production. Its permanent-magnet design and integrated feedback help the connected amplifier monitor motion continuously and correct for changing load conditions.

The motor uses frame code 063 and a centering diameter of 95 mm, allowing direct mounting to gearheads or machine plates with minimal alignment effort. Under rated winding excitation, the rotor reaches a nominal speed of 6000 rpm, which permits high surface velocities in compact spaces and supports fast machine cycles. Heat generated during operation is removed through natural convection, so no external blower or coolant is required and surrounding layouts can remain simple. A built-in blocking brake provides holding torque of 3 Nm, allowing vertical or indexed axes to remain locked when power is removed. The compact mounting geometry also helps when the motor must fit beside neighboring actuators, covers, or guarding.

Electrical termination is through a connector on side B, which keeps power cabling opposite the driven shaft and helps simplify routing in tight cabinets. That cable orientation can also keep the harness away from couplings, pulleys, or other moving machine elements near the output end. The motor uses a tachogenerator that produces 1.5 V/1000 rpm, providing a standard signal for analog velocity loops without additional sensors. Rotor position is reported by an incremental encoder, while winding code FS identifies the electrical characteristics used by compatible drive modules. The D length gives the motor a longer housing within this frame size, increasing the active stack length without changing the centering diameter.