Product Description:

The MAC063D-0-FS-4-C-095-A-1-WI517LV is an AC servo motor produced by Bosch Rexroth Indramat for the MAC AC Servo Motors series. Classified as a motor for analog drives, it receives commanded voltages from legacy drive modules and converts them into controlled torque and speed for industrial positioning tasks. Typical stations include indexing tables, printing cylinders, and small gantry axes where tight velocity control is essential. Integrated mechanical and electrical interfaces match earlier MAC units, which helps preserve established mounting patterns and cable routing in existing machine layouts.

Mechanically, the motor uses a 95 mm centering diameter that aligns the flange to gearboxes or brackets without shims. Frame code 063 identifies a compact stator size, yet the motor still reaches a rated shaft speed of 6000 rpm under nominal supply. Thermal losses are removed by natural convection, eliminating the need for forced air or liquid circuits and keeping the installation simple. A blocking brake is installed as standard and can hold up to 3 Nm when power is removed, which helps prevent back-driving on vertical axes or other load-bearing arrangements. Motor length code D extends the active core, increasing continuous torque without changing the mounting interface.

The winding set is identified by code FS, matching the motor to MAC drive amplifiers that supply the correct current. Power enters through a connector on side A, which supports straightforward cable routing when the motor is installed with the flange facing the machine. Speed feedback for the analog velocity loop comes from a built-in tachogenerator that delivers 1.5 V/1000 rpm, giving the drive a linear signal for speed regulation. Position verification is provided by an incremental encoder, which sends pulse information that the control system can use to monitor shaft movement and confirm commanded motion.