Product Description:

The MAC063D-0-FS-1-C/095-A-1/I500 is a compact AC servo motor built by Bosch Rexroth Indramat for the MAC AC Servo Motors series. Classified as a motor for analog drives, it converts drive controller commands into precise rotary motion for industrial positioning and velocity loops. With a 63 mm frame, it fits light-to-medium duty axes where rapid speed changes and repeatable accuracy are required. This type of motor is commonly used where the drive must regulate shaft motion smoothly during indexing, feed movement, or continuous speed control. Because it is intended for closed-loop motion, the motor is suitable for machines that need steady response to changing commands and load conditions.

A centering diameter of 95 mm aligns the motor flange with the machine interface and helps maintain concentricity under dynamic loading. The rotor can reach a nominal speed of 6000 rpm, allowing fast cycle times when paired with appropriately rated mechanical transmissions. Heat is removed through natural convection, so no external blowers or liquid circuits are required. Position and velocity data are returned through incremental encoder feedback, which lets the connected drive track shaft motion in real time. All power conductors exit through a connector on side A, which keeps cable routing consistent in compact multi-axis layouts. This arrangement supports orderly wiring where moving machine parts leave limited space around the motor body.

A blocking brake is included, and it can apply 3 Nm of static torque to hold loads when the drive is disabled. The tachogenerator outputs 1.5 V per 1000 rpm, giving the analog controller a proportional speed signal for regulation at low shaft speeds. The FS winding gives the electrical resistance and inductance values expected by a compatible drive. Its D-length housing provides additional active stack depth without increasing the flange footprint. This feedback mix allows the drive to monitor shaft speed and position during operation.