Product Description:

The MAC063C-0-HS-3-C/095-A-1/WI 515LV is an AC servo motor produced by Bosch Rexroth Indramat within the MAC AC Servo Motors series. It is intended for analog drive systems that require closed-loop velocity and position control on compact axes in assembly lines, pick-and-place modules, and light machining centers. In these systems, the motor converts commanded current into rotary motion that can be regulated for stable running speed and accurate stopping. Its integrated feedback arrangement allows the paired drive to monitor shaft motion continuously, which supports repeatable response during short-travel indexing and rapid reversals.

The rotor is centered by a 95 mm pilot diameter that matches standard flange patterns and helps keep mechanical alignment consistent at the mounting face. Nominal speed reaches 6000 rpm, allowing fast traverse cycles without external gear multiplication and giving the axis a wide operating range before a gearbox becomes necessary. A blocking brake rated at 3 Nm holds the axis when power is off, which helps prevent unwanted movement at a stop. Heat is removed through natural convection, so no forced-air components are required. Speed feedback is generated by a tachometer with an output of 1.5 V/1000 rpm, which keeps the analog velocity signal proportional to motor speed.

The motor uses frame size 063 with stack length code C, which gives a balanced mix of torque capacity and thermal mass for this housing size. Position data are supplied by an incremental encoder, and the motor also includes a second shaft end for the tachometer arrangement used on this configuration. The HS winding sets the electrical characteristics that the matching drive must support for rated current delivery, including the resistance and inductive behavior expected by the amplifier. Power cabling enters through a connector on side A, which helps reduce cable bends in tight enclosures and can simplify routing near adjacent machine members.